Dell PowerVault NX300 Hardware Owner's Manual - Page 130
Press the battery toward the negative side of the connector and lift it, the connector.
View all Dell PowerVault NX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
3 Remove the system board shroud. See "Removing the System Board Shroud" on page 101. Figure 3-25. Replacing the System Battery 2 1 3 1 positive side of battery connector 3 negative side of battery connector 2 system battery 4 Locate the battery socket. See "Jumpers and Connectors" on page 171. CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery. 5 Remove the system battery. a Support the battery connector by firmly holding the positive side of the connector. b Press the battery toward the negative side of the connector and lift it up out of the securing tab at the negative side of the connector. 6 Install the new system battery. a Support the battery connector by pressing down firmly on the positive side of the connector. 130 Installing System Components