Dell PowerVault NX300 Hardware Owner's Manual - Page 136
Remove all hard drives. See Removing a Hot-Swap Hard Drive on, retention hooks.
View all Dell PowerVault NX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
4 Remove all hard drives. See "Removing a Hot-Swap Hard Drive" on page 85. 5 Disconnect the power cable from the end of the SAS backplane. 6 Disconnect the SAS data cables from the backplane. 7 Remove the SAS backplane from the system: a While pulling the two blue latches towards the front of the system, slide the backplane upward. See Figure 3-28. b When the backplane cannot slide upward any farther, pull the backplane toward the back of the system to remove it from the retention hooks. c Lift the board out of the system, being careful to avoid damaging components on the face of the board. d Place the SAS backplane face down on a work surface. 136 Installing System Components
136
Installing System Components
4
Remove all hard drives. See "Removing a Hot-Swap Hard Drive" on
page 85.
5
Disconnect the power cable from the end of the SAS backplane.
6
Disconnect the SAS data cables from the backplane.
7
Remove the SAS backplane from the system:
a
While pulling the two blue latches towards the front of the system,
slide the backplane upward. See Figure 3-28.
b
When the backplane cannot slide upward any farther, pull the
backplane toward the back of the system to remove it from the
retention hooks.
c
Lift the board out of the system, being careful to avoid damaging
components on the face of the board.
d
Place the SAS backplane face down on a work surface.