Dell Precision Tower 7810 Dell Precision Tower 7810 Owners Manual - Page 20
Installing the Hard Drive, Removing the HDD Thermal Sensor
View all Dell Precision Tower 7810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installing the Hard Drive 1. If a 3.5-inch hard drive is installed on the computer, place the hard drive and press in on the latches of the hard-drive caddy. 2. If a 2.5-inch hard drive is installed on the computer, place the hard drive on the hard-drive caddy and tighten the screws to secure the hard drive. 3. Secure the hard-drive in the hard-drive cage and slide it inside the compartment. 4. Connect the hard-drive power supply cable and data cable. 5. Install the computer cover. 6. Follow the procedures in After Working Inside Your Computer. Removing the HDD Thermal Sensor NOTE: The HDD thermal sensor is an optional component and your computer may not ship with it. 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the computer cover. 3. Identify the HDD thermal sensor connected to the system board. 4. Disconnect the HDD thermal sensor cable from the system board. 20