Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.1 - Page 1017

Version 7.5.1.0 pre-6.2.1.1 Description Introduced on the C-Series. Introduced on the E-Series. Usage Information The following describes the show mac-address-table command shown in the following example. Column Heading Description VlanId Displays the VLAN ID number. Mac Address Displays the MAC address in nn:nn:nn:nn:nn:nn format. Type Lists whether the MAC address was manually configured (Static), learned dynamically (Dynamic), or associated with a specific port (Sticky). Interface Displays the interface type and slot/port information. The following abbreviations describe the interface types: • Po = port channel • Gi = gigabit Ethernet • Te = ten-gigabit Ethernet State Lists if the MAC address is in use (Active) or not in use (Inactive). Example DellEMC(conf)# do show mac-address-table Codes: *N - VLT Peer Synced MAC VlanId Mac Address Type 2 00:00:00:00:00:01 Dynamic (N) 2 00:00:00:00:00:02 Dynamic (N) 2 00:00:00:00:00:03 Dynamic 2 00:00:00:00:00:04 Dynamic Interface Po 128 Po 10 Po 100 Po 10 State Active Active Active Active Usage Information The following describes the show mac-address-table count command shown in the following example. Line Beginning Description With MAC Entries... Displays the number of MAC entries learned per VLAN. Dynamic Address... Lists the number of dynamically learned MAC addresses. Static Address... Lists the number of user-defined MAC addresses. Total MAC... Lists the total number of MAC addresses the switch uses. Example (Count) DellEMC# show mac-address-table count MAC Entries for all vlans : Dynamic Address Count : 110 Static Address (User-defined) Count : 0 Sticky Address Count : 0 Total Synced Mac from Peer(N): 100 Total MAC Addresses in Use: 110 DellEMC# Related Commands • show mac-address-table aging-time - display MAC aging time. Layer 2 1017