Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.1 - Page 1042

Usage Information The following describes the show fefd command shown in the following example. Field Interface Description Displays the interfaces type and number. Mode Displays the mode (aggressive or normal) or NA if the interface contains fefd reset in its configuration. Interval Displays the interval between FEFD packets. State Displays the state of the interface and can be one of the following: • bi-directional (interface is up, connected and hearing neighbor's echoes). • err-disabled (only found when FEFD mode is aggressive and when the interface has not hearing its neighbor's echoes for three times the message interval. To reset an interface in this state, use the fefd reset command.) • unknown (only found when FEFD mode is normal. • locally disabled (interface contains the fefd reset command in its configuration). • Admin Shutdown (interface is disabled with the shutdown command). Example DellEMC# show fefd FEFD is globally 'ON', interval is 10 seconds, mode is 'Aggressive'. INTERFACE MODE Gi 5/1 Aggressive Gi 5/2 Aggressive Gi 5/3 Aggressive Gi 5/4 Aggressive Gi 5/5 Aggressive Gi 5/6 Aggressive Gi 5/7 Aggressive Gi 5/8 Aggressive Gi 5/9 Aggressive Gi 5/10 NA Gi 5/11 Aggressive DellEMC# INTERVAL (second) 10 10 10 10 10 10 10 10 10 NA 10 STATE Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Locally disabled Err-disabled Related Commands • fefd - enable far-end failure detection. • fefd disable - disable FEFD on an interface only. • fefd-global - enable FEFD globally on the system. • fefd reset - reset all interfaces or a single interface that was in "error-disabled" mode. 1042 Layer 2