Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.1 - Page 1314

Version 7.5.1.0 Description Introduced on the E-Series. redirect Configure a rule for the redirect list. Syntax redirect {ip-address | slot/port} | tunnel tunnel-id}[track ] {ipprotocol-number | protocol-type [bit]} {source mask | any | host ip-address} {destination mask | any | host ip-address} [operator] To remove this filter, use one of the following: • Use the no seq sequence-number command if you know the filter's sequence number. • You can also use the no redirect {ip-address | slot/port}| tunnel tunnel-id}[track ] {ip-protocol-number [bit] | protocol-type} {source mask | any | host ip-address} {destination mask | any | host ip-address} [operator] command. Parameters redirect ip-address slot/port tunnel tunnel-id track track ip-protocol-number protocol-type Enter the keyword redirect to assign the sequence to the redirect list. Enter the IP address of the forwarding router. Enter the keyword slot / port followed by the slot/port information. Enter the keyword tunnel to configure the tunnel setting. Enter the keyword tunnel-id to redirect the traffic. Enter the keyword track to enable the tracking. Enter the keyword track to track object-id. Enter a number from 0 to 255 for the protocol identified in the IP protocol header. Enter one of the following keywords as the protocol type: • icmp for internet control message protocol • ip for any internet protocol • tcp for transmission control protocol • udp for user datagram protocol bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) • psh = push function • rst = reset the connection • syn = synchronize sequence number • urg = urgent field source mask Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). 1314 Policy-based Routing (PBR)