Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.1 - Page 210

show ip access-lists Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and the count of matches/mismatches against each ACL entry displayed. Syntax Parameters show ip access-lists [access-list-name] [interface interface] [in | out] [vrf vrf-name] access-list-name interface interface Enter the name of a configured MAC ACL, up to 140 characters. Enter the keyword interface followed by the one of the following keywords and slot/ port or number information: • For a VLAN interface, enter the keyword vlan followed by the slot/port number. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. in | out vrf vrf-name Identify whether ACL is applied on the ingress or egress side. Enter the keyword vrf and then the name of the VRF to display the access-lists that are configured on either the default or non-default VRFs. Command Modes Command History EXEC Privilege This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 8.5.1.0 8.3.19.0 8.3.11.1 8.3.7.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Added support for the 4-port 40G line cards on the E-Series. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Standard IP ACL Commands When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit. 210 Access Control Lists (ACL)