Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.1 - Page 1128

35 Multicast The multicast commands are supported by Dell EMC Networking OS. Topics: • IPv4 Multicast Commands • IPv6 Multicast Commands IPv4 Multicast Commands The following section contains the IPv4 multicast commands. clear ip mroute Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base, use the clear ip pim tib command. Syntax Parameters clear ip mroute [vrf vrf-name] {group-address [source-address] | *} vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this setting on that VRF. NOTE: Applies to specific VRF if input is provided, else applies to Default VRF. group-address [source-address] * Enter the multicast group address and source address (if desired), in dotted decimal format, to clear information on a specific group. Enter * to clear all multicast routes. Command Modes Command History EXEC Privilege This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.11.(3.0) 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) Description Removed support for keyword snooping. Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. 1128 Multicast