Dell S3100 EMC Command Line Reference Guide for the Series 9.14.2.1 - Page 1864

description "Red Network" DellEMC(conf-vrf)# DellEMC(conf-if-gi-1/45)# int gi 1/46 DellEMC(conf-if-gi-1/46)# no shut DellEMC(conf-if-gi-1/46)# ip vrf forwarding red DellEMC(conf-if-gi-1/46)# ip add 100.1.1.1/24 DellEMC(conf-if-gi-1/46)# DellEMC(conf-if-gi-1/46)# DellEMC(conf-if-gi-1/46)# DellEMC(conf-if-gi-1/46)# show config ! interface GigabitEthernet 1/46 ip vrf forwarding red ip address 100.1.1.1/24 no shutdown DellEMC(conf-if-gi-1/46)# ip route-export Enables route leaking between VRFs. This command exports or shares IPv4 routes corresponding to one VRF with other nondefault VRFs. Syntax ip route-export tag [route-map-name] Parameters route-export Enter the keywords route-export to leak or share routes between VRFs. tag Enter a tag (export route target) to expose routes to other VRFs. This tag acts as an identifier for exported routes. Use this identifier while importing these routes into another nondefault VRF. route-map-name (Optional) Enter the name of the route-map to filter the exported routes. You can leak global routes to VRFs. As the global RTM usually contains a large pool of routes, when the destination VRF imports global routes, these routes are duplicated into the VRF's RTM. It is mandatory to use route-maps to filter out leaked routes while sharing global routes with VRFs. Command Modes • VRP mode • CONFIGURATION mode Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC Networking OS Command Line Reference Guide. Version 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) Description Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. 1864 Virtual Routing and Forwarding (VRF)