Dell S5830dn Smart Printer User Guide - Page 92
Universal Setup menu, Standard Bin, Bin [x], Units of Measure, Notes, Portrait Width, Portrait Height
View all Dell S5830dn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
Understanding printer menus Use Standard Bin Bin [x] Universal Setup menu Use Units of Measure Inches Millimeters Portrait Width 3-14.17 inches 76-360 mm Portrait Height 3-14.17 inches 76-360 mm Feed Direction Short Edge Long Edge 92 To Specify a custom name for the standard bin. Specify a custom name for Bin [x]. To Identify the units of measure. Notes: • Inches is the U.S. factory default setting. • Millimeters is the international factory default setting. Set the portrait width. Notes: • If the width exceeds the maximum, then the printer uses the maximum width allowed. • 8.5 inches is the U.S. factory default setting. You can increase the width in 0.01‑inch increments. • 216 mm is the international factory default setting. You can increase the width in 1‑mm increments. Set the portrait height. Notes: • If the height exceeds the maximum, then the printer uses the maximum height allowed. • 14 inches is the U.S. factory default setting. You can increase the height in 0.01‑inch increments. • 356 mm is the international factory default setting. You can increase the height in 1‑mm increments. Specify the feed direction if the paper can be loaded in either direction. Notes: • Short Edge is the factory default setting. • Long Edge appears only when the longest edge is shorter than the maximum width supported in the tray.