Dell XPS 13 9315 XPS 13 9315 / XPS 9315 Service Manual - Page 22

Display assembly, Removing the display assembly

Get Dell XPS 13 9315 PDF manuals and user guides View all Dell XPS 13 9315 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

NOTE: If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure that thermal conductivity is achieved. The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure. Steps 1. Align the screw holes of the heat sink with the screw holes of the system board. 2. In sequential order (1>2>3>4), tighten the four screws (M2x3) that secure the heat sink to the system board. Next steps 1. Install the base cover. 2. Follow the procedure in After working inside your computer. Display assembly Removing the display assembly Prerequisites 1. Follow the procedure in Before working inside your computer. 2. Remove the base cover. About this task The following image(s) indicate the location of the display assembly and provides a visual representation of the removal procedure. 22 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
NOTE:
If either the system board or the heat sink is replaced, use the thermal grease that is provided in the kit to ensure
that thermal conductivity is achieved.
The following image(s) indicate the location of the heat sink and provides a visual representation of the installation procedure.
Steps
1.
Align the screw holes of the heat sink with the screw holes of the system board.
2.
In sequential order (1>2>3>4), tighten the four screws (M2x3) that secure the heat sink to the system board.
Next steps
1.
Install the
base cover
.
2.
Follow the procedure in
After working inside your computer
.
Display assembly
Removing the display assembly
Prerequisites
1.
Follow the procedure in
Before working inside your computer
.
2.
Remove the
base cover
.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the removal
procedure.
22
Removing and installing components