Denon 2106 Operating Instructions - Page 49

ENGLISH Advanced Setup - Part 1 Option Setup Setting the Trigger Out Setup • Two 12 V DC Trigger Outputs on the rear panel can be used to control other devices with compatible trigger inputs, such as motorized screens, motorized screen masking, motorized drapes, and other trigger-controlled devices. • Set the DC output supplied from the trigger out terminals for the various input sources to "ON" or "OFF". 1 Press the CURSOR D or H button to select "Option Setup" at the "System Setup" menu, then press the ENTER button. • The "Option Setup" menu appears. Setting the Muting Level This sets the amount of attenuation applied for audio output muting. 1 Press the CURSOR D or H button to select "Muting Level" at the "Option Setup" menu, then press the ENTER button. • The "Muting Level" screen appears. Advanced Setup - Part 1 Setting the On Screen Display (OSD) • Use this to turn the on screen display (messages other than the menu screens) "ON" or "OFF". • Sets the on screen display mode. 1 Press the CURSOR D or H button to select "On Screen Display" at the "Option Setup" menu, then press the ENTER button. • The "On Screen Display" screen appears. 2 Press the CURSOR D or H button to select "Trigger Out1 Setup", then press the ENTER button. • The "Trigger Out1 Setup" screen appears. 2 Press the CURSOR F or G button to select the desired setting. -20 dB: Attenuation of the volume by -20 dB from the present level. -40 dB: Attenuation of the volume by -40 dB from the present level. - - - dB: The volume level is completely muted. 3 Press the ENTER button to enter the setting. • The "Option Setup" menu appears. 2 Press the CURSOR F or G button to select "ON" or "OFF". 3 Press the CURSOR D or H button to select the on screen display mode, then press the CURSOR F or G button to select "MODE1" or "MODE2". MODE1: Prevents flickering of the on screen display when there is no video signal. MODE2: Flickering is not prevented. Use this mode if the on screen display does not appear in MODE1, which may happen depending on the TV being used. 3 Press the CURSOR D or H button to select the input source, then press the CURSOR F or G button to select "ON" or "OFF". 4 Press the ENTER button to enter the setting. • The "Option Setup" menu appears. 4 Press the ENTER button to enter the setting. • The "Option Setup" menu appears. • Set the Trigger out 2 setup in the same way. 46 ENGLISH