Denon 2106 Operating Instructions - Page 57

Advanced Setup - Part 2 System setup items and default values (set upon shipment from the factory) 1. Auto Setup / Room EQ 1 Auto Setup Auto Setup / Room EQ Power Amp Assign. Set this to switch the surround back channel's power amplifier for ZONE2 or BiAmp use . 2 Manual EQ Setup This parameter is for optimizing the Room EQ with which the audio signals are produced from the speakers. 3 Room EQ Setup Set the Room EQ setting with "All" or "Assign" for each surround mode. 4 Direct Mode Setup Set the ON/OFF setting of Room EQ, in the case of the surround mode is in "Direct" or "Pure Direct". Default setting SURROUND BACK All Channel and Frequency = 0 dB All OFF Page 8~11 52 52, 53 53 2. Speaker Setup 1 Speaker Config. Speaker Setup Input the combination of speakers in your system and their corresponding sizes (SMALL for regular speakers, LARGE for full-size, full-range) to automatically set the composition of the signals output from the speakers and the frequency response. Front Sp. Large 2 Delay Time 3 Channel Level This parameter is for optimizing the timing with which the Front audio signals are produced from the speakers and L & R subwoofer according to the listening position. 12 ft This adjusts the volume of the signals output from the Front Front speakers and subwoofer for the different channels in order L R to obtain optimum effects. 0 dB 0 dB 4 Crossover Frequency Sets the frequency (Hz) below which the bass sound of the various speaker is to be output from the subwoofer. 5 SW Mode Setup This selects the subwoofer speaker for playing deep bass signals. Default setting Center Sp. Subwoofer Surround Sp. Surround Back Sp. Small Yes Small Small / 2sp Center Subwoofer Surround L & R Surround Back L & R 12 ft 12 ft 10 ft 10 ft Center Surround L Surround R Surround Back L Surround Back R Subwoofer 0 dB 0 dB 0 dB 0 dB 0 dB 0 dB 80 Hz LFE (Normal) Page 48 49 49, 50 50 50 ENGLISH Advanced Setup - Part 2 54 ENGLISH