Denon 2106 Operating Instructions - Page 52

ENGLISH Advanced Setup - Part 2 Setting the Delay Time Input the distance between the listening position and each speaker to set the delay time for the surround playback. Preparations: Measure the distances between the listening position and the speakers. FL Center FR Subwoofer Listening position SL SR SBL SBR 4 Press the ENTER button to enter the setting. • The "Speaker Setup" menu appears. Setting the Channel Level • Use this setting to balance the playback levels in different channels and make them appear equal. • From the listening position, listen to the test tones produced from the speakers to adjust the level. • The levels can also be adjusted directly from the remote control unit ( page 50). 1 Press the CURSOR D or H button to select "Channel Level" at the "Speaker Setup" menu, then press the ENTER button. • The "Channel Level" screen appears. Advanced Setup - Part 2 4 When "Auto" mode is selected: Press the CURSOR F or G button to adjust all -1 the speakers to the same volume. • The test tones are emitted from each speaker in the following order: at 4-second intervals during the first and second cycle, and at the 2-second intervals during the third and subsequent cycles. FL C FR SR 2sp SW SL SBL SBR SB 1sp When the surround back speaker setting is set to "1sp" for "Speaker Configuration", this is set to "SB". Example: When the volume is set to -12.0 dB while the test tone is being produced from the Front Lch speaker 1 Press the CURSOR D or H button to select "Delay Time" at the "Speaker Setup" menu, then press the ENTER button. • The "Delay Time" screen appears. 2 Press the CURSOR D or H button to select the speaker to be set. 3 Press the CURSOR F or G button to set the distance between the speaker and the listening position. The distance changes in units of 1 foot each time the button is pressed. Select the value closest to the measured distance. If "Yes" is selected for "Default", the settings are automatically reset to the default values. The difference in distance for the various speaker settings must not be greater than 20 ft. 2 Press the CURSOR F or G button to select "Auto" or "Manual". Auto: Adjust the level while listening to the test tones produced automatically from each speaker. Manual: Select the speaker from which you want to produce the test tone to adjust the level. 3 Press the CURSOR D or H button to select "TEST TONE Start", then press the CURSOR F button to select "Start". The volume can be adjusted between -12 dB and +12 dB in units of 0.5 dB. 4 When "Manual" mode is selected: Press the CURSOR D or H button to select the -2 speaker, then press the CURSOR F or G button to adjust all the speakers to the same volume. 5 Press the ENTER button to enter the setting. • The "Speaker Setup" menu appears. 49 ENGLISH