Denon 2106 Operating Instructions - Page 6
Operating range of the remote control unit, Part names and functions, Inserting the batteries - setup
UPC - 081757506571
View all Denon 2106 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ENGLISH Getting Started Inserting the batteries q Remove the remote control unit's rear cover. w Set two R6P/AA batteries in the battery compartment in the indicated direction. e Put the rear cover back on. Notes on batteries: • Replace the batteries with new ones if the set does not operate even when the remote control unit is operated nearby the unit. (The included batteries are only for verifying operation.) • When inserting the batteries, be sure to do so in the proper direction, following the "" marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • When replacing the batteries, have the new batteries ready and insert them as quickly as possible. Part names and functions Getting Started Front panel For details on the functions of these parts, refer to the pages given in parentheses ( ). @7 @2 @0 #5 #4 #3 #2 #1 #0 @9 @8 @6 @5 @4 @3 @1 !9 t u o !1 q w e r y i !0 !4 !2 !3 !5 !6 !7 !8 Operating range of the remote control unit • Point the remote control unit at the remote sensor on the main unit as shown in the diagram. • The remote control unit can be used from a straight distance of approximately 23 feet from the main unit, but this distance will be shorter if there are obstacles in the way or if the remote control unit is not pointed directly at the remote sensor. • The remote control unit can be operated at a horizontal angle of up to 30 degrees with respect to the remote sensor. Approx. 23 feet 30° 30° NOTE: • It may be difficult to operate the remote control unit if the remote sensor is exposed to direct sunlight or strong artificial light. • Do not press buttons on the main unit and remote control unit simultaneously. Doing so may result in malfunction. • Neon signs or other devices emitting pulsetype noise nearby may result in malfunction, so keep the set as far away from such devices as possible. q Power ON/STANDBY switch 8) w Power indicator 8) e Power switch 8, 40) r Headphones jack (PHONES 20) t ANALOG button 20) y SPEAKER A/B buttons 20, 40) u ZONE2 button 39) i Preset station select buttons 30, 31) o STANDARD/NIGHT button 22~25) !0 5CH/7CH STEREO button 26) !1 STEREO/DIRECT/PURE DIRECT button 21) !2 V. AUX INPUT terminals 13) !3 SETUP MIC jack 8) !4 SURROUND MODE button 19) !5 SURROUND PARAMETER button 22) !6 SELECT knob 19, 22, 29) !7 TONE DEFEAT button 29) !8 TONE CONTROL button 29) !9 MASTER VOLUME control knob 19) @0 TUNING • (up)/ª (down) buttons ·····(30) @1 STATUS button 20, 25) @2 DIMMER button 20) @3 VIDEO SELECT button 20) @4 OUTPUT indicator 24, 39) @5 Master volume indicator 19) @6 Display @7 INPUT mode indicator 21) @8 SIGNAL indicator 21) @9 BAND button 30) #0 EXT. IN button 19) #1 Remote control sensor 3) #2 INPUT MODE button 20) #3 ZONE2/REC SELECT button 39, 40) #4 FUNCTION knob 19, 39) #5 MAIN button 19) 3 ENGLISH