Denon S-302 Owners Manual - English - Page 15
Connecting the Monitor - speaker stands
UPC - 081757507882
View all Denon S-302 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Getting Started Connections Setup Playback Remote Control Information Troubleshooting Protector circuit The protection circuit will be activated in the following cases: • When the speaker output is short-circuited • When the temperature around the set is extremely high • When the set is used for long periods of time with a high output and the internal temperature rises When the protection circuit is activated, the speaker output is cut off and the power indicator flashes. Should this occur, please follow these steps: be sure to switch off the power of this unit, check whether there are any faults with the wiring of the speaker cables or input cables, and wait for the unit to cool down if it is very hot. Improve the ventilation condition around the unit and switch the power back on. If the protection circuit is activated again even though there are no problems with the wiring or the ventilation around the unit, switch off the power and contact a DENON service center. Mounting the speaker stand and bracket b Be sure to tighten the screws completely. b Also be careful when installing. Screws (included) Speaker Stand (included) ENGLISH Connecting the Monitor Select and connect using one of the video cables below according to the TV's terminals. The terminals provide playback with different picture qualities, in the following order (from highest to lowest): qHDMI terminals, wComponent video terminals, eS-Video terminals, rVideo terminals Monitor )%.* */ 7*%&0 */ 7*%&0 47*%&0 */ $0.10/&/57*%&0 */ : 1# 13 Note on speaker impedance If speakers with an impedance below the specified impedance (4 Ω/ohms) are used (for example, speakers with an impedance of 3 Ω/ohms) with the volume turned up high for long periods of time, the temperature may rise, activating the protective circuit. When the protection circuit is activated, the output to the speakers is cut off and the power indicator blinks. If this happens, unplug the power supply cord, wait for the set to cool off and improve ventilation around the unit. Also check the wiring of the input cables and the speaker cables. After doing this, plug the power supply cord back in and turn the unit's power back on. If the protection circuit is activated again even though there are no problems with the wiring or the ventilation around the unit, switch off the power and contact a DENON service center. Wall Screws (included) Wall bracket (included) Anti slip pads here. b When placing the speaker system (SC-S302) on a stand, etc., stick the included cushion pads at the two corners of the bottom surface. (Refer to the illustration below.) Switching the video output format Set the HDMI/PROGRESSIVE/INTERLACED switch on the rear panel according to the video output format of the TV connected to the set. b Be sure to turn the power off before operating the switch. The component video terminals may be indicated differently on your TV. For details, see the TV's operating instructions. 11