Denon S-302 Owners Manual - English - Page 35

Getting Started Connections Setup Playback Remote Control Information Troubleshooting Playing Dolby Digital/DTS MultiChannel Sources (Digital input only) 1 Switch the input source (vpage 24). (DVD, AUX1 or AUX2 digital input) 2 Use [SURROUND] to select the "DOLBY VS REF" or "DOLBY VS WIDE". The " " indicator lights. 3 Play sources with the or mark sources. The " " or " " indicator lights, depending on the playback source's signal format. 4 Use [SURROUND PARAMETER] to display the various surround parameters, then select with [o p]. [Selectable items] D.COMP LFE Playing Dolby Digital 2-Channel Sources 1 Switch the input source (vpage 24). 2 Use [SURROUND] to select the "DOLBY VS REF" or "DOLBY VS WIDE". The " " indicator lights. 3 Play sources with the mark. The " " indicator lights, depending on the playback source's signal format. 4 Use [SURROUND PARAMETER] to display the various surround parameters, then select with [o p]. [Selectable items] D.COMP LFE ENGLISH To check the currently playing source and various settings In the stop mode, press [STATUS]. b The playback source and the various surround settings are shown on the display each time the button is pressed. Listening in the Dolby Headphone Mode 1 Switch the input source (vpage 24). Plug the headphones (sold separately) into the jack. The sound from the speakers is automatically cut off. Listening to Radio Broadcasts Tuning in Broadcast Stations 1 Use or [FM/AM] to select "TUNER". : "TUNER" (vpage 17) 2 Use or [FM/AM] to select the reception band. FM AUTO FM MONO AM 2 Press [SURROUND] to select the "DOLBY H/P" The " " indicator lights. 3 Play the source. 3 Use , [TUNING +/-] or [o p] to select the reception frequency. When a station is received, the "TUNED" indication will light. 4 Use [SURROUND PARAMETER] to display the various surround parameters, then select with [o p]. [Selectable items] D.COMP LFE CINEMA MUSIC NOTE Be careful not to set the volume too high when using headphones. A humming sound may be heard when using a TV nearby while receiving AM programs. If this happens, move the system as far from the TV as possible. Display of the FM broadcast reception status • When the reception band mode is set to "FM AUTO" and a stereo broadcast is tuned in, the "ST" indicator lights. • If the signal is weak and stable stereo reception is not possible, set the reception band mode to "FM MONO" and receive the program in monaural. The "MONO" indicator lights. Main unit button There are two, switchable modes fo the tuning mode for setting the reception frequency (setting upon purchase), and the preset mode for selecting the preset broadcast station. n Switching the preset mode Pressing while pressing in . "PRESET" is flashes for approximately 5 seconds. n Switching the tuning mode Pressing while pressing in . "TUNING" is flashes for approximately 5 seconds. Auto tuning When , [TUNING +/-] or [o p] is pressed and held in, the set automatically starts searching for a broadcast station. b Stations whose signal is weak cannot be tuned in. 31