Denon S-302 Owners Manual - English - Page 18

Getting Started Connections Setup Playback Remote Control Information Troubleshooting ENGLISH Antenna Terminals An F-type FM antenna cable plug can be connected directly. AM/FM Direction of broadcasting station FM antenna AM loop antenna (Supplied) 75 Ω/ ohms Coaxial cable AM loop antenna assembly Remove the vinyl tie and take out the connection line. Connect to the AM antenna terminals. Mount Bend in the reverse direction. a. With the antenna on top any stable surface. b. With the antenna attached to a wall. External Controller Video Recorder etc. 015*$"*/ Infrared retransmitter Extension jack for future use. Input Output Infrared "69
sensor 065 FM indoor antenna (Supplied) Black White Installation hole Mount on wall, etc. Connection of AM antennas 1. Push the lever. 2. Insert the conductor. 3. Return the lever. RS-232C connector Ground AM outdoor antenna Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. NOTE • Do not connect two FM antennas simultaneously. • Even if an external AM antenna is used, do not disconnect the AM loop antenna. • Make sure the AM loop antenna lead terminals do not touch metal parts of the panel. This connector is used for an external controller. b If you wish to control the S-302 from an external controller using the RS-232C connector, perform the operation below beforehand. q Turn the S-302's power. w Turn off the S-302's power from the external controller. e Check that the S-302 is in the standby mode. 14