Epson ActionNote 880C User Manual - Fax/Data Modem - Page 62

test ends, and the test result is reported., Example 2 - Test timer enabled

Get Epson ActionNote 880C PDF manuals and user guides View all Epson ActionNote 880C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 62 highlights

Here, the test timer is disabled and the modem sets up an internal analog loop as shown in Figure 4-1. When the loopback is established, the modem goes on-line and the test message (any character you type) is looped back on the screen for verification. Finally, +++ returns the modem to the command state and &T0 ends the test and breaks the internal analog loop. The following command sequence is the same as the previous one except that the test timer is set to 60 seconds. At the end of the test time, the timer expires, the test ends, and the test result is reported. Example 2 - Test timer enabled Command: AT/N1 ATS18=60&T1 Result: cursor shifts down one line Test message: THE QUICK BROWN FOX JUMPS OVER THE LAZY DOG 1234567890 Escape: OK 4 - TESTING 55

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
Here, the test timer is disabled and the modem sets up an internal analog loop as
shown in Figure 4-1. When the loopback is established, the modem goes on-line
and the test message (any character you type) is looped back on the screen for verifi-
cation. Finally, +++ returns the modem to the command state and &T0 ends the
test and breaks the internal analog loop.
The following command sequence is the same as the previous one except that the
test timer is set to 60 seconds. At the end of the test time, the timer expires, the
test ends, and the test result is reported.
Example 2 - Test timer enabled
Command:
AT/N1<CR>
ATS18=60&T1 <CR>
Result:
cursor shifts down one
line
Test message:
THE QUICK BROWN FOX JUMPS OVER
THE LAZY DOG 1234567890
Escape:
OK
4
-
TESTING
55