Epson C823622A Administrator's Manual - Page 21

Status sheet button The first time you use the interface card after installing or 1 reinstalling it, turn on the printer while holding down the status sheet button for about five seconds to initialize the interface card. Before you start configuring the interface card, be sure to press the status sheet button on the interface card for about three seconds to print a status sheet. A status sheet shows important information such as the current configuration, the serial number, and the MAC address. You will need this information to configure the interface card. You cannot print a status sheet if the printer has started printing, if it is off-line, or if it is not ready to print. Note: If the printer does not print a status sheet, make sure that the printer is on-line and no print jobs are being processed, then wait a minute before trying again. If it still does not print a status sheet, turn the printer off, wait until the status lights go out, and then turn it on again. c Caution: After turning off the printer, wait until the status lights go out before turning it back on; otherwise the interface card may not work correctly. Network connectors The interface card can detect which kind of cable is attached. You do not need to make any hardware or software settings to specify the cable type. However, you must not attach more than one cable at a time. 10BASE-2 (C82362✽ only) Connect the Ethernet thin coaxial (10BASE-2) cable to the BNC connector on the interface card using the supplied Y-connector. Getting Started 1-3