Epson C823622A Administrator's Manual - Page 54
NLSP with RIP/SAP Compatibility or b RIP/SAP Only. If, to the NetWare servers and IPX routers.
![]() |
UPC - 010343832404
View all Epson C823622A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
You can select either of the following routing protocols; a) NLSP with RIP/SAP Compatibility or b) RIP/SAP Only. If you remove the bind of RIP or SAP when NLSP with RIP/ SAP Compatibility is specified, the interface card is not able to communicate with the file server and NDS. (See "Protocols" and "Bindings" in NetWare's INETCFG utility.) Time required to recognize the interface card It takes up to two minutes for the NetWare server to recognize the interface card after turning on the printer. During this start-up time, the status sheet does not show the correct information. Frame type The same frame type should be used for the NetWare server and IPX router on the same network. If more than one frame type is used on the same network, bind the all the frame types to the NetWare servers and IPX routers. Instruction for NetWare 5 The IPX protocol must be installed (bound) to the NetWare 5 server. Instruction for mode If the mode you have logged in is different from the mode you set for the interface card, a message appears when you try to configure the interface card for NetWare. If you do not want to change the current settings, click Cancel and log in again in the same mode as you set for the interface card. 3-4 Using the Interface Card with NetWare
![](/manual_guide/products/epson-c823622a-administrators-manual-53386bc/54.png)