Epson ES-600C User Manual - Page 24

SCSI Model, connector., directions

Get Epson ES-600C PDF manuals and user guides View all Epson ES-600C manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

3. Connect the 36pin end of the cable to the scanner; then fasten the connector with the clamps on the sides of the connector. Warning: Do not conned more than one interface cable to the scanner at a time. Always use a shielded cable. SCSI Model For this model, you use either the Epson SCSI Kit for DOS Computers or the Epson SCSI Kit for the Macintosh. The DOS kit includes a SCSI board for your computer, a cable, and software. You install the SCSI board in your computer, following the instructions in your computer manual. Then follow the directions below to connect your scanner and computer. All Macintoshes have SCSI ports, so the Macintosh kit contains only the cable and software. Follow the directions below to connect the scanner to your Macintosh. 2-4 Connecting the Sumner to the Computer

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
3.
Connect the 36pin end of the cable to the scanner; then
fasten the connector with the clamps on the sides of the
connector.
Warning:
Do not conned more than one interface cable to the scanner at
a time. Always use a shielded cable.
SCSI Model
For this model, you use either the Epson SCSI Kit for DOS
Computers or the Epson SCSI Kit for the Macintosh. The DOS
kit includes a SCSI board for your computer, a cable, and
software. You install the SCSI board in your computer,
following the instructions in your computer manual. Then
follow the directions below to connect your scanner and
computer. All Macintoshes have SCSI ports, so the Macintosh
kit contains only the cable and software. Follow the
directions
below to connect the scanner to your Macintosh.
2-4
Connecting the Sumner to the Computer