Epson ES-600C User Manual - Page 27
Terminator setting, Connecting the SCSI
View all Epson ES-600C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Terminator setting If the scanner is the only SCSI device you are going to connect to your computer or if it is the last device in the daisy chain, leave the terminator on. The terminator is on when Switch 1 of the terminator switches, located between the SCSI connector on the rear panel, is on. See below for the location of the switches. The scanner should always be the last device on the daisy chain. You do not need to change the factory settings for the terminator switches as long as the scanner is the only SCSI device or the last SCSI device in the daisy chain. If you decide to connect the scanner in the middle of the daisy chain, turn terminator Switch 1 off. (Switch 2 must always be off.) Connecting the SCSI connect the scanner with the SCSI as follows: 1. See that the scanner, the computer, and all other SCSI devices are turned off and unplugged from the power source. Connecting the Scanner to the Computer 2-7