Epson Stylus Pro 3880 Designer Edition Network Guide - Page 13

Install, Internet Protocol Version 4 TCP/IPv4, TCP/IPv4 Properties dialog box. Set the IP address

Get Epson Stylus Pro 3880 Designer Edition PDF manuals and user guides View all Epson Stylus Pro 3880 Designer Edition manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

3. Check if the following network components are in the list. If they are already installed, go to "Connecting the Network Interface to the Network" on page 16. The following table lists the network components required for configuring the network interface with EpsonNet Config. EpsonNet Config's setting screens TCP/IP, SNMP (IP trap) Necessary components Internet Protocol (TCP/IP) The following table lists the network components required for network printing. Printing method LPR printing Necessary components Internet Protocol (TCP/IP) 4. If the necessary components are not in the list, click Install to install them. 5. Double-click Internet Protocol Version 4 (TCP/IPv4) on the Local Area Connection Properties dialog box to open the Internet Protocols Version 4 (TCP/IPv4) Properties dialog box. Set the IP address, the subnet mask, etc. and then click OK. 6. Restart the computer. The necessary components are now installed. Go to the section "Connecting the Network Interface to the Network" on page 16. Setting Up Your System for Network Printing 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
Setting Up Your System for Network Printing
13
3.
Check if the following network components are in the list. If they are
already installed, go to “Connecting the Network Interface to the Network”
on page 16.
The following table lists the network components required for configuring
the network interface with EpsonNet Config.
The following table lists the network components required for network
printing.
4.
If the necessary components are not in the list, click
Install
to install them.
5. Double-click
Internet Protocol Version 4 (TCP/IPv4)
on the Local Area
Connection Properties dialog box to open the Internet Protocols Version 4
(TCP/IPv4) Properties dialog box. Set the IP address, the subnet mask,
etc. and then click
OK
.
6.
Restart the computer.
The necessary components are now installed. Go to the section “Connecting
the Network Interface to the Network” on page 16.
EpsonNet Config’s setting screens
Necessary components
TCP/IP, SNMP (IP trap)
Internet Protocol (TCP/IP)
Printing method
Necessary components
LPR printing
Internet Protocol (TCP/IP)