Epson TM H6000 Technical Reference - Page 32
PD160R, AF50KS-E - dip switch
View all Epson TM H6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
1.5.4.3 Paper Specifications Paper type: Form: Paper width: Paper roll size: Specified paper (see Chapter 1 more details): Paper roll spool diameter: Specified thermal paper Paper roll 79.5 ± 0.5 mm (3.13" ± 0.02") Roll diameter: Maximum 83 mm (3.27 in.) Take-up paper roll width: 80+0.0/-1.0 mm (3.15+0.02/-0.04 in.) Specified thermal roll paper, NTP080-80 In Japan: Nakagawa, Seisakujo In USA: Nakagawa Mfg. (USA) Inc. In Europe: Nakagawa Mfg. (Europe) GmbH In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD [Original paper: TF50KS-E Nippon Paper Industries Co.,Ltd.] The following paper can be used instead of the specified paper above: Original paper: PD 160R (Oji Paper Mfg. Co. Ltd.) Original paper: AF50KS-E (Jujo Thermal Oy (Finland)) Original paper: P350(F380), P310, P300 (Kanzaki Specialty Papers, Inc. (U.S.A.)) Inside: 12 mm (.47") Outside: 18 mm (.71") Note:Paper must not be pasted to the paper roll spool. When paper other than that specified is used, the thermal print head may be worn out.Be sure to use the specified paper. Depending on each paper specification, it is recommended to set the DIP switch as shown in Table below: Original paper type P350 (F380) PD160R, AF50KS-E, P310, P300 DIP SW2 3 4 ON ON OFF OFF Print density level 1 2 1-18 General Information Rev. A