Epson TM H6000 Technical Reference - Page 78
Memory Switches
View all Epson TM H6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
3.4.4.5 When Using Original Paper When you use original paper such as P350 (F380), we recommend setting the DIP switches as shown in the table below. The setting differs depending on each paper specification. See the Other Qualified Suppliers for Thermal Paper section later in this chapter. DIP SW2 Original paper type 3 4 P350 (F380) ON ON PD160R, AF50KS-E, P310, P300 OFF OFF Print density level 1 2 Note: See the thermal paper section in Chapter 4 for information about thermal paper. 3.4.5 Memory Switches This printer has "Memory switches" which are software switches. A memory switch setting utility can change the memory switch 1 or 8 to ON or OFF as shown in the table below (default: all OFF): • Switch 1 Bit 1 2 ~8 ON OFF Transmits the power ON notice Does not transmit the power ON notice Reserved (Do not change the setting) • Switch 8 Bit ON OFF 1-2 Reserved (Do not change the setting) 3 Uses a 58 mm width roll paper Uses an 80 mm width roll paper 4 Uses two-color roll paper Uses monochrome roll paper 5-6 Reserved (Do not change the setting) 7 Slip paper jam detection: Disabled Slip paper jam detection: Enabled 8 Becomes recoverable error if the unit cover is open Goes offline if the unit cover is open during printing during printing Note: Settings of the memory switch are stored in the NV memory; therefore, even if the printer is turned off, the settings are maintained. Excessive use of this function may destroy the NV memory. As a guideline, do not use this function more than 10 times a day. For information about the Memory switch utility, please contact your dealer or EPSON. When you use OPOS or APD, generally you don't need to adjust memory switch because OPOS or APD are able to set these items automatically. 3-24 Setup Rev. A