Epson V11H179020 User Manual - Page 62

Wait until the lamp has cooled down, then remove the, Loosen the two lamp screws.

Get Epson V11H179020 - PowerLite S3 SVGA LCD Projector PDF manuals and user guides
UPC - 010343853997
View all Epson V11H179020 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 62 highlights

Maintenance PROCEDURE A After you turn off the projector's power, and the confirmation buzzer beeps twice, disconnect the power cable. B Wait until the lamp has cooled down, then remove the lamp cover from the base of the projector. Loosen the lamp cover screw with the screwdriver that is supplied with the spare lamp (or your own cross head [Phillips] screwdriver). Then slide the lamp cover straight forward and lift it to remove. 62 C Loosen the two lamp screws. Loosen the two lamp screws with the screwdriver that is supplied with the spare lamp (or your own cross head [Phillips] screwdriver). D Take out the lamp. Hold the lamp as shown in the illustration below and lift it up and out of the projector. If the lamp is broken, replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be careful to avoid pieces of broken glass.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
62
Maintenance
PROCEDURE
A
After you turn off the projector’s power, and the
confirmation buzzer beeps twice, disconnect the
power cable.
B
Wait until the lamp has cooled down, then remove the
lamp cover from the base of the projector.
Loosen the lamp cover screw with the screwdriver that is
supplied with the spare lamp (or your own cross head [Phillips]
screwdriver).
Then slide the lamp cover straight forward and lift it to remove.
C
Loosen the two lamp screws.
Loosen the two lamp screws with the screwdriver that is
supplied with the spare lamp (or your own cross head [Phillips]
screwdriver).
D
Take out the lamp.
Hold the lamp as shown in the illustration below and lift it up
and out of the projector.
If the lamp is broken, replace it with a new lamp, or contact
your local dealer for further advice. If replacing the lamp
yourself, be careful to avoid pieces of broken glass.