Fujitsu MAB3091SC Product Manual - Page 34
SCSI Function Specifications, Synchronous mode - jumpers
![]() |
View all Fujitsu MAB3091SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
2.2 SCSI Function Specifications Table 2.3 shows the SCSI functions provided with the IDD. See Appendix E for the SCSI interface functions provided for the IDD. Refer to the OEM Manual -SCSI Physical Specifications-, for details or specifications. Table 2.3 SCSI function specifications Item Specification Single-ended type Ο Differential type × Electrical Single-ended type Position where the terminating Ο requirements resistor is mounted on the PCA Differential type Position where the terminating × resistor is mounted on the PCA TERMPWR signal send/receive function Ο Non-shielded type (50 mil pitch): 16-bit SCSI Ο Connector Shielded type × Data bus parity Ο Bus arbitration function Ο Disconnection/reconnection function Ο SCSI ID Addressing 8-bit SCSI 16-bit SCSI #0 to #7 (Jumper selection) #0 to #15 (Jumper selection) LUN (logical unit number) #0 fixed Asynchronous mode Data transfer Synchronous mode 8-bit SCSI 16-bit SCSI 8-bit SCSI 16-bit SCSI Ο 6 MB/s max. Ο 12 MB/s max. Ο 20 MB/s max. Ο 40 MB/s max. Data buffer 512-KB programmable segment buffer (1 to 16) Data block length (Logical data length=Physical data length) 512 to 528 bytes (Fixed length) Ο : Provided × : Not provided C141-E035-03EN 2 - 7
![](/manual_guide/products/fujitsu-mab3091sc-product-manual-55de9e5/34.png)