Fujitsu MAB3091SC Product Manual - Page 90
Mounting Drives, 5.4.1 Check before mounting, 5.4.2 Mounting procedures
![]() |
View all Fujitsu MAB3091SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
5.4 Mounting Drives 5.4.1 Check before mounting Reconfirm if the setting terminals are set correctly before mounting the drive in the system cabinet. For setting terminals location, see Section 5.3. (1) Single-ended 16-bit SCSI model (MAx3xxxSP) Reconfirm if the setting terminals are set correctly according to Table 5.7. Setting terminal CN6 Table 5.7 Setting check list (MAx3xxxSP) No. Setting contents (Check item) Setting position 1 Terminal power supply CN6 1 - 2 2 Motor start mode CN6 3 - 4 3 Connection of terminating CN6 5 - 6 resistor on SCSI interface Check Remarks Short Short Short Open Open Open Setting terminal CN7 No. Setting contents (Check item) 1 SCSI ID 2 Write protect Setting position CN7 7 - 8 5 - 6 3 - 4 1 - 2 CN7 13 - 14 Check (SCSI ID = __) Remarks Short Open 5.4.2 Mounting procedures Since mounting the drive depends on the system cabinet structure, determine the work procedures considering the requirements specific to each system. The general mounting method and items to be checked are shown below. See Subsection 4.2 for the details of requirements for installing the IDD. 1) With a system to which an external operator panel is mounted, if it is difficult to access the connector after the drive is mounted on the system cabinet, connect the external operator panel cable before mounting the drive. 2) Fix the drive in the system cabinet with four mounting screws as follows: • The drive has 10 mounting holes (both sides: 3 ×2, bottom: 4). Fix the drive by using four mounting holes of both sides or the bottom. C141-E035-01EN 5 - 11
![](/manual_guide/products/fujitsu-mab3091sc-product-manual-55de9e5/90.png)