Garmin GPSMAP 178C Owners Manual - Page 117
Messages, Track Memory Is Full Can't Create Track - repair
UPC - 753759043544
View all Garmin GPSMAP 178C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Proximity Alarm List is Full- You have used all ten proximity waypoints. Proximity Alarm Waypoint- You have entered the alarm radius for the proximity waypoint indicated. Proximity Overlaps Another Proximity Waypoint-The alarm radius specified overlaps the area specified for another proximity waypoint. Adjust the distance. Route Already Exists: - You have entered a route name that already exists in memory. Modify the route name or delete the previous route name. Route Does Not Exist: - Route has been renamed or removed from memory and cannot be used. Route Is Full- You have attempted to add more than 50 points to a route. Reduce the number of points or create a second route. Route Memory Is Full Can't Create Route- Maximum amount of 50 routes is already in the unit's memory and no additional routes can be added until existing ones are removed. Route Truncated- An uploaded route from another device has more than 50 points. Reduce the number of points. Running Simulator- The unit is in simulator (practice) mode. Shallow Water Alarm- Specified shallow water alarm depth has been detected below transducer. Sonar Failed Unit Needs Repair- Internal problem with the unit. Contact your dealer or Garmin Product Support (page. iv) to have the unit serviced. Track Already Exists: - You have entered a saved track name that already exists in memory. Modify the track name or delete the previous track name. Appendix D Messages Track Memory Is Full Can't Create Track- Track log memory is full. No additional track log data can be stored without deleting old data to create memory space. Track Truncated- A complete uploaded track does not fit into memory. The oldest track log points were deleted to make space for the most recent data. Transducer Disconnected Sonar Turned Off- No transducer attached or bad cable/transducer. Transfer Complete- The unit has finished uploading/downloading information to the connected device. Water Speed Sensor is Not Working- Speed sensor is not detected. Check connections. Waypoint Already Exists: - You have entered a waypoint name that already exists in memory. Modify the waypoint name or delete the previous waypoint name. Waypoint Memory Is Full Can't Create Waypoint- You have used all 3000 waypoints available. Delete unwanted waypoints to make space for new entries. 107