HP 625 Compaq 325 and 326 Notebook PCs HP 425 and 625 Notebook PCs - Maintenan - Page 64
Memory module, on each side of the memory module slot to release the memory
View all HP 625 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
Memory module NOTE: When adding a second memory module, be sure it is the same type and speed as the installed memory module. Description 2-GB (PC3-10600, 1333-MHz, DDR3) 1-GB (PC3-10600, 1333-MHz, DDR3) Spare part number 598856-001 598859-001 Before removing the memory module, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 48). 5. Remove the service door (see Service door on page 49). Remove the memory module: 1. Position the computer right-side up with the front toward you. 2. Spread the retaining tabs (1) on each side of the memory module slot to release the memory module. (The edge of the module opposite the slot rises away from the computer.) 3. Remove the memory module (2) by pulling the module away from the slot at an angle. NOTE: Memory modules are designed with a notch to prevent incorrect insertion into the memory module slot. Reverse this procedure to install a memory module. 54 Chapter 4 Removal and replacement procedures