HP 625 Compaq 325 and 326 Notebook PCs HP 425 and 625 Notebook PCs - Maintenan - Page 87
Remove the power switch board, and then slide the board out of the retainer
View all HP 625 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Remove the power switch board: 1. Release the ZIF connector (1) and disconnect the ribbon cable (2) from the system board. 2. Remove the Phillips M2.5×3.0 broadhead screw (1) that secures the board to the base pan, raise the end of the board (2), and then slide the board out of the retainer (3). Reverse this procedure to install the power switch board. Component replacement procedures 77
Remove the power switch board:
1.
Release the ZIF connector
(1)
and disconnect the ribbon cable
(2)
from the system board.
2.
Remove the Phillips M2.5×3.0 broadhead screw
(1)
that secures the board to the base pan,
raise the end of the board
(2)
, and then slide the board out of the retainer
(3)
.
Reverse this procedure to install the power switch board.
Component replacement procedures
77