HP BladeSystem bc2500 Setup and Installation Guide HP BladeSystem bc2000 and b - Page 75
Is the Enclosure Power LED on the Rear Panel Green?
View all HP BladeSystem bc2500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Table D-4 Is the Enclosure Power LED on the Rear Panel Green? Answer Possible Reasons Possible Solutions No, it is off. The cable is not properly connected between the fan backplane and the power backplane. Be sure that the connectors on the fan cable are properly seated and not damaged. The interconnect tray is not fully inserted. Remove and reseat the interconnect tray. The Integrated Administrator module is Contact HP or your authorized service provider for not properly seated. parts and service. The fan backplane assembly has failed. The connector on the power backplane is damaged. The power backplane has failed. No, it is amber. The enclosure is in standby mode. Push the enclosure power button on the fan cage at the rear of the enclosure. Caution: Pressing the enclosure power button while the enclosure is running shuts down the enclosure and all blade PCs. Yes, it is green. If the enclosure power LED is green, return to Table D-1 Enclosure diagnostic steps on page 64. Table D-5 Is the Enclosure Health LED on the Front of the Enclosure On? Answer Possible Reasons Possible Solutions No, it is off. The enclosure status cable is disconnected from the center wall assembly or the enclosure status assembly. Securely attach the enclosure status cable. The enclosure status assembly or the center wall assembly is not functioning properly. Contact HP or your authorized service provider for parts and service. Yes, it is amber. A system component is degraded but your system is still functional. Check your local or remote console for error messages. Go to Table D-6 Is the Local Management Console Displaying Information When Connected to the Enclosure? on page 68 Check system fans. Go to Table D-8 Is the Fan Health LED Green? on page 69 Contact HP or your authorized service provider for parts and service. ENWW Enclosure diagnostic steps 67