HP Cluster Platform Interconnects v2010 Gigabit Ethernet Interconnect Guide - Page 36
ProCurve 5308xl Rear View, Table 5-1 Switch Chassis LEDs
View all HP Cluster Platform Interconnects v2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Table 5-1 Switch Chassis LEDs (continued) LEDs State Status/Fan (green) Flashing On Flashing Status/Power (green - numbers corresponding to the power supply positions) On Off Flashing Status / Modules (green - letters corresponding to the switch module slots) On Off LED Mode Select (3 green LEDs) Flashing Act FDx Max ! Meaning A component of the switch has failed its self test. The Status LED for that component, for example a switch module, and the switch Fault LED will flash simultaneously. The cooling fans are operating normally. One or more of the cooling fans have failed. The switch Fault LED will be flashing simultaneously. A power supply is installed in the position in the back of the switch corresponding to the number, and the supply is plugged in to an active AC power source. As shipped, the switch has a single power supply in position 1. A power supply is not installed in the position corresponding to the number. The power supply installed in the position corresponding to the number is not plugged in to an active AC power source, or has experienced a fault. The switch Fault LED will be flashing simultaneously. A module is installed in the switch module slot corresponding to the letter and the module is undergoing or has passed self test. This also occurs when you hot swap a module when the switch is already powered on. A module is not installed in the switch module slot corresponding to the letter. The module status LED flashes very briefly when a module is being hot swapped. If the LED flashes for a prolonged time, the module in the slot corresponding to the letter has failed self test or encountered some other fault condition. Indicates that the port Mode LEDs are displaying network activity information. Indicates that the port Mode LEDs are lit for ports that are in Full Duplex Mode. Indicates that the port Mode LEDs are lit for ports that are operating at their maximum possible link speed -- for any Gigabit-capable connection, that would be 1000 Mbps; for the 10/100-TX ports and 100-FX ports, that would be 100 Mbps. Indicates that specific error packets are being detected on the port. In this mode, the Mode LED for the port will flash briefly for each error packet that is detected, for example CRC errors or late collisions. 5.1.2 ProCurve 5308xl Rear View The rear of the ProCurve 5308xl (Figure 5-2) has an AC power connector. It does not have a power switch. It is powered on when connected to an active AC power source, and automatically adjusts to any voltage between 100-127 and 200-240 volts and either 50 or 60 Hz. There are no voltage range settings required. 36 HP ProCurve 5308xl