HP Cluster Platform Interconnects v2010 Gigabit Ethernet Interconnect Guide - Page 46
HP ProCurve 5308 Mounted in a Rack, In general
View all HP Cluster Platform Interconnects v2010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Figure 5-9 HP ProCurve 5308 Mounted in a Rack 5. Connect the switch to a power source. 6. Re-check the LEDs during self test. 7. Connect the network devices. Refer to the cabling tables for your cluster. Note: In general, when a network cable from an active network device is connected to the switch, the Link LED for the switch port should go on. If the Link LED does not go on, see the module documentation for troubleshooting procedures. 46 HP ProCurve 5308xl
Figure 5-9 HP ProCurve 5308 Mounted in a Rack
5.
Connect the switch to a power source.
6.
Re-check the LEDs during self test.
7.
Connect the network devices. Refer to the cabling tables for your cluster.
Note:
In general, when a network cable from an active network device is connected to the switch,
the Link LED for the switch port should go on. If the Link LED does not go on, see the
module documentation for troubleshooting procedures.
46
HP ProCurve 5308xl