HP ENVY m6-n012dx HP ENVY m6 Notebook PC Maintenance and Service Guide - Page 62
Connector board, Disconnect the connector board cable
View all HP ENVY m6-n012dx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Connector board Description Connector board (includes audio jack, RJ-45 jack, USB port, and 2 cables) Spare part number 760038-001 Before removing the connector board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 28), and then remove the following components: a. Service cover (see WLAN module on page 29) b. Hard drive (see Hard drive on page 32) c. Base enclosure (see Base enclosure on page 39) Remove the connector board: 1. Disconnect the connector board cable (1) from the system board. 2. Release the connector board cable from the retention clips built into the top cover (2) and the subwoofer (3). 3. Release the ZIF connector (4) to which the connector board ribbon cable is attached, and then disconnect the connector board ribbon cable from the system board. 4. Detach the connector board ribbon cable (5) from the base enclosure. (The connector board ribbon cable is attached to the top cover with double-sided tape.) 54 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts