HP EliteOne 1000 Maintenance and Service Guide - Page 59
Computer Setup—Security, Computer Setup-Main continued
View all HP EliteOne 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Table 5-1 Computer Setup-Main (continued) Option Description ● Ownership Tag Replicated Setup Backup current settings to USB device Saves system configuration to a formatted USB flash media device. Restore current settings from USB device Restores system configuration from a USB flash media device. Save Custom Defaults Saves the current system configuration settings as the custom default set. Apply Custom Defaults and Exit Applies the custom default settings to the computer after rebooting. Does not apply to options in the Security menu. Apply Factory Defaults and Exit Restores the factory system configuration settings to the computer after rebooting. Does not apply to options in the Security menu. Ignore Changes and Exit Exits Computer Setup without applying or saving any changes. Save Changes and Exit Saves changes to current system configuration, exits Computer Setup, and reboots. Suppress POST errors Select to turn off any errors generated by Power On Self Test (POST) during boot up. Computer Setup-Security NOTE: Support for specific Computer Setup options may vary depending on the hardware configuration. Table 5-2 Computer Setup-Security Option Description Create BIOS Administrator Password Lets you set and enable a BIOS administrator password, which controls access to the following features: ● Setup Menu (F10) ● 3rd Party Option ROM Management (F3) ● Update system ROM ● WMI commands that change system settings ● BIOS Configuration Utility (BCU) ● Alternative power-on password NOTE: Creating a BIOS user disables the Fast Boot option. NOTE: If the password is set, it is required to change Computer Setup options, update the BIOS, and make changes to certain plug and play settings under Windows. Change BIOS Administrator Password (This selection is active only if a BIOS administrator password is set.) Lets you change the BIOS administrator password. You must know the current password to be able to change it. Create POST Power-On Password The power-on password prompt appears after a power cycle or reboot. If the user does not enter the correct power-on password, the unit will not boot. Change POST Power-On Password (This selection is active only if a BIOS Lets you change the POST power-on password. You must know the current password to be able to change it. Computer Setup (F10) Utilities 51