HP EliteOne 1000 Maintenance and Service Guide - Page 65
Table 5-3, USB Type-C Connector System Software Interface UCSI
View all HP EliteOne 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Table 5-3 Computer Setup-Advanced (for advanced users) (continued) Option Heading Virtualization Technology (VTx) (Intel only) Controls the virtualization features of the processor. Changing this setting requires turning the computer off and then back on. Default is disabled. Virtualization Technology for Directed I/O (VTd) (Intel only) Controls virtualization DMA remapping features of the chipset. Changing this setting requires turning the computer off and then back on. Default is disabled. M.2 SSD Lets you disable the M.2 solid-state drive slot. Default is enabled. M.2 WLAN/BT Lets you disable the wireless module slot. Default is enabled. Allow PCIe/PCI SERR# Interrupt (enable/disable) Allows PCI devices to report PCI/PCIe System Error signals, such as address parity errors, data parity errors, and critical errors other than parity. Default is enabled. Power Button Override (disable/4 sec/15 sec) Lets you disable or enable and select the number of seconds you have to hold down the power button for it to force the system to power off. Default is '4 sec'. USB Type-C Connector System Software Interface (UCSI) (enable/disable) Default is enabled. Built-In Device Options Embedded LAN Controller Select to show the device in the operating system. Default is enabled. Wake On LAN Lets you either disable the Wake On LAN feature, or configure where the computer boots, including the network or hard drive. Default is Boot to Network. Allow No Panel configuration When enabled, POST blink and beep codes and error messages are not generated. Default is disabled. Video memory size Use this option to manage graphics memory allocation. The value you choose is allocated permanently to graphics and is unavailable to the operating system. Integrated Camera Clear to disable the integrated camera. Default is enabled. Audio Device Select to show the device in the operating system. Default is enabled. Microphone Clear to disable the microphone. This does not affect devices plugged into audio jacks. Default is enabled. Internal Speakers (does not affect external speakers) Clear to disable the chassis speaker or speakers. This function is applicable to normal audio playback in the operating system and does not affect the error or warning beeps during POST. Default is enabled. Headphone Output Clear to disable the headphone jack. Default is enabled. Computer Setup (F10) Utilities 57