HP GbE2c HP BladeSystem c7000 Enclosure Maintenance and Service Guide - Page 42

Interconnect switch or Pass-Thru module - c class switch

Get HP GbE2c - Blc Layer 2/3 Fiber SFP Option PDF manuals and user guides
UPC - 808736802215
View all HP GbE2c manuals
Add to My Manuals
Save this manual to your list of manuals

Page 42 highlights

2. Remove the blank. CAUTION: For best cooling practices, do not operate the enclosure for extended periods with more than one component or blank removed. When removing an active component, replace it with a blank. To replace the component, slide the component into the bay until it locks into place. Interconnect switch or Pass-Thru module CAUTION: This procedure provides instructions for replacement of a failed part only. To change the configuration of components, see the appropriate HP BladeSystem c-Class enclosure setup and installation guide. To remove the component: CAUTION: To prevent data loss, redirect network activity or be sure that all critical network activity has stopped before removing the interconnect module. IMPORTANT: An SFP port must be occupied by an SFP transceiver or an SFP dust cover at all times. 1. Disconnect all cables from the component. 2. Press the release tab. 3. Open the handle. Removal and replacement procedures 42

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
Removal and replacement procedures
42
2.
Remove the blank.
CAUTION:
For best cooling practices, do not operate the enclosure for extended periods with
more than one component or blank removed. When removing an active component, replace
it with a blank.
To replace the component, slide the component into the bay until it locks into place.
Interconnect switch or Pass-Thru module
CAUTION:
This procedure provides instructions for replacement of a failed part only. To
change the configuration of components, see the appropriate HP BladeSystem c-Class
enclosure setup and installation guide.
To remove the component:
CAUTION:
To prevent data loss, redirect network activity or be sure that all critical network
activity has stopped before removing the interconnect module.
IMPORTANT:
An SFP port must be occupied by an SFP transceiver or an SFP dust cover at all
times.
1.
Disconnect all cables from the component.
2.
Press the release tab.
3.
Open the handle.