HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 22
Refer to A-1, System Board Layout, in Appendix A, SCSI Device Selection
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Chapter 3 Installing Mass Storage Devices • IDE Devices o The embedded IDE controller is an Enhanced-IDE dual channel controller and provides two connectors (IDE-1 and IDE-2) for IDE devices. Refer to Figure A-1,"System Board Layout," in Appendix A, "Specifications." o The IDE CD-ROM has only one connector on the cable from the primary channel (IDE-1) connector. o A secondary IDE connector (IDE-2) is available, but is not used. • SCSI Device Selection o Use only HP LVD low profile (1 inch) SCSI 3.5-inch hard disk drives for the Hot Swap drive bays. o If mounting available SCSI drives in drive trays, ensure you use the mounting tray adapter recommended by HP, which is HP part number P2452A. o Ensure the SCSI devices you install in Hot Swap bays do not have terminations installed. The Hot Swap backplane provides automatic termination for any unused bays. The HP Hot Swap SCSI drives come set without device ID or termination. Do not change these settings. o Do not use high voltage differential (HVD) SCSI devices on either of the SCSI channels or damage will occur. o The embedded dual-channel Ultra-3 SCSI controller includes connectors for SCSI channels A and B. o Channel A is used for connection to the SCSI backplane board, which provides three 80-pin connectors for Hot Swap SCSI drives. The standard SCSI cable has one 68-pin, high-density connector for the SCSI backplane, which provides for automatic termination of the SCSI drives. o Channel B is used to control external mass storage devices, including an external backup tape drive. Channel B is connected to the external 68-pin SCSI connector on the rear of the Netserver. 16