HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 53
Installing a Second Processor
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
Chapter 6 Installing an Additional Processor Installing a Second Processor This section provides the instructions for installing a second processor and its accompanying heatsink on the system board. CAUTION The processor is sensitive to static electricity and can be easily damaged by improper handling. Do the following when handling the accessory kit: • Leave the processor in the anti-static bag until you are ready to install it. • Wear an anti-static wrist strap and use a static-dissipating work surface or grounding mat connected to the chassis when handling components. • Before you remove a processor from the anti-static bag, touch a grounded, unpainted metal surface on the HP Netserver LP 1000r to discharge static electricity. 1. Unpack the processor shipping box and check the contents against its packing list. CAUTION Do not remove the processor from its bag and ensure the bag remains sealed until you are ready to install it. 2. If the Netserver is already installed and operating, shut down the NOS according to directions in your NOS documentation. 3. Press the power switch on the HP Netserver's control panel when prompted by the operating system. Normally, this completes the shutdown procedure. WARNING Power supplies will continue to provide standby current to the Netserver until the power cables are disconnected. 4. Disconnect the AC power cord. 5. Gain access to the system board by following the appropriate instructions for removing the chassis from the rack and removing the cover. 47