HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 69
Preparing the Rack, HP Netserver Rack Mount Parts List
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Chapter 7 Rack Mounting the HP Netserver (2-Post) • Circuit Overloading - Ensure the total configuration of equipment in the rack does not overload the supply circuit. To this end, check the nameplate ratings on all equipment. Consider the effect of circuit overloading on overcurrent protection and supply wiring. • Reliable Earth Grounding - Maintain reliable earth grounding of rack-mounted equipment. Give particular attention to supply connections that are not direct connections to the branch circuit (for example, using non-HP power strips). Preparing the Rack The hole placement on the two columns must be marked before attempting to mount the HP Netserver chassis. Once the two holes on both columns are marked correctly, the rails and hardware can be removed from the Netserver chassis and the new brackets can be mounted on the chassis. Once the brackets are installed the Netserver can be mounted onto the columns. HP Netserver Rack Mount Parts List Ensure the rack-mounting kit provided with the HP Netserver contains the following parts: Table 7-1. Parts for Rack Mount Kit Quantity 2 2 8 4 Description Flush mount brackets (one left and one right side) Center mount brackets (one left and one right side) Bracket mounting screws (8-32 x ¼ inch, Torx head) Rack mounting screws (12-24 Phillips head) Marking the Rack Use this section to mark the columns of the 2-post non-HP rack. The brackets attach to the front side of the two columns for either flush mount or center mount brackets. The masking tape (or marking pen) is used to identify and mark the locations on the columns. CAUTION If other rack components are to be mounted in the rack below the HP Netserver, install those components before starting to mount the Netserver. 63