HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 46
Riser Board and Securing Clamp
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Chapter 5 Installing Additional Boards 8. Remove the securing clamp from the chassis and set it aside for re-assembly later. Securing Clamp Riser Board Figure 5-3. Riser Board and Securing Clamp 9. Lift up the latch and move the slot cover to the left away from the tabs and out of the chassis as shown in Figure 5-4. The PCI slot cover is held in place by the latch and must be saved for use later. NOTE Save the slot cover for use later if the PCI board is removed. The slot cover must be installed in the empty PCI slot to prevent EMI interference. 40
Chapter 5
Installing Additional Boards
40
8. Remove the securing clamp from the chassis and set it aside for
re-assembly later.
Securing Clamp
Riser Board
Figure 5-3. Riser Board and Securing Clamp
9. Lift up the latch and move the slot cover to the left away from the tabs and out of the
chassis as shown in Figure 5-4.
The PCI slot cover is held in place by the latch and must be saved for use later.
NOTE
Save the slot cover for use later if the PCI board is removed.
The slot cover must be installed in the empty PCI slot to
prevent EMI interference.