HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 71
Preparing the HP Netserver, See
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 7 Rack Mounting the HP Netserver (2-Post) Preparing the HP Netserver Each HP Netserver has two inner-rails attached at the factory and shipped to customers. These two inner-rails must be removed to attach the brackets before the Netserver can be mounted in the rack. 1. Lay the HP Netserver on a flat surface. 2. Remove the front bezel on the Netserver chassis, if not already removed. See Figure 7-3. Optional (2) Figure 7-3. Removing Existing Hardware 3. Remove the screws holding the inner-rails and spacers on each side of the chassis. See Figure 7-3. 4. If mounting flush mount brackets, remove the screws holding the front mounting brackets to each side of the chassis. See Figure 7-3. 5. Locate the brackets in the kit. a. If you are mounting the HP Netserver as a flush mount, you only need the two flush mount brackets mounted on the front of the chassis. 65