HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 49
Removing the Accessory Board, Clamping Long PCI Boards
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Chapter 5 Installing Additional Boards d. Close the latch and then close the board clamp onto the edge of the PCI board. See Figure 5-6. 15. When you have completed the PCI aboard installation, close the Netserver and return it to the rack where power can be applied. 16. Once the Netserver is returned to normal operation, you may need to install software drivers. The drivers for the new PCI board are either part of your existing system software or included on a flexible diskette or CD-ROM provided with the accessory board. Step C Lower Board Latch Step B Insert Between Tabs Step A Open Clamp Step D Close Clamp Board Clamp Tab Rest Figure 5-6. Clamping Long PCI Boards Removing the Accessory Board Follow the same steps as the installation procedure, but in reverse order. Replace the slot cover. See the preceding sections for details. 43