HP LC2000r HP Netserver LP 1000r (1.13, 1.26 & 1.40 GHz) User Guide - Page 82
Marking the Columns, Releasing Spring Assembly
View all HP LC2000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
Chapter 8 Rack Mounting the HP Netserver (4-Post) 3/4 CCW Release Spring Assembly 1/4 CW Figure 8-2. Releasing Spring Assembly Marking the Columns Use this section to mark the front and rear columns of the HP System/E or HP System/U rack. The outer-rails mount to the face of the front columns and the inside face of the rear columns. The masking tape (or marking pen) is used to identify and mark the locations on the columns. CAUTION If other rack components are to be mounted in the rack below the HP Netserver, install those components before starting to mount the Netserver. NOTE Use the HP Rack Configuration Tools to determine where in the rack to mount the HP Netserver. The tools are available at: http://www.hp.com/netserver/support 1. Find the EIA unit markings on the rack and the location for the Netserver. 76