HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 14

procedure. See Step 3., See

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Chapter 1 Server Administration Using HP TopTools NOTE Ensure you label any cables attached to the PCI board (disk controller, NIC, etc.), to identify it later when connecting the cable to the new or replacement PCI board. 9. Release the PCI hold-down latch to remove the board from the PCI slot. a. Press the center of the PCI hold-down latch (should hear a click). See Figure 8. b. Pull the latch to half open (allows the board to clear the latch). See Figure 8. B. Pull latch to half open from rear. A. Push here to release (should click). NOTE 10 Figure 8. Releasing the PCI Board The HP NetServer is shown with its top cover removed for clarity. Only the PCI Access Panel should be removed for this procedure. See Step 3.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
Chapter 1
Server Administration Using HP TopTools
10
NOTE
Ensure you label any cables attached to the PCI board (disk
controller, NIC, etc.), to identify it later when connecting the
cable to the new or replacement PCI board.
9.
Release the PCI hold-down latch to remove the board from the PCI slot.
a.
Press the center of the PCI hold-down latch (should hear a click).
See Figure 8.
b.
Pull the latch to half open (allows the board to clear the latch).
See Figure 8.
A. Push here
to release
(should click).
B. Pull latch
to half open from rear.
Figure 8. Releasing the PCI Board
NOTE
The HP NetServer is shown with its top cover removed for
clarity. Only the PCI Access Panel should be removed for this
procedure. See Step 3.