HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 36
Do Not Drop Screws or Other Metal Objects into the HP
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Appendix B Warranty, Software License and Support Off board from this slot. 9. If the Slot Status for the desired PCI slot changes to Powered Off, go to next section, "Removing a Hot Plug Board", to physically remove the PCI board from the PCI slot (slot P5). Removing a Hot Plug Board Use this topic to physically remove a PCI Hot Plug Board from its PCI slot. 1. At the front of the HP NetServer, remove the front bezel from the NetServer (refer to your Installation Guide). 2. Extend the HP NetServer chassis safely from the rack (refer to your Installation Guide). 3. Remove the PCI Access Panel (refer to your Installation Guide). CAUTION Do Not Drop Screws or Other Metal Objects into the HP NetServer. 4. Verify power to the desired PCI slot is turned off, by checking the power LED associated with the desired PCI slot. See Figure 24 and Table 7. The green Power LED must be OFF, before attempting to open the PCI hold-down latch. 32