HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 43
Open the Novell Configuration Manager Console NCMCON, if
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Chapter 2 A. Push the PCI hold-down latch in from the rear. PCI Hot Plug Utility for Novell NetWare B. The latch should click into place. C. Close the latch on the PCI board guide. Figure 29. Closing the PCI Hold-Down Latch NOTE If the PCI hold-down latch does not fully close (click), the slot will not be powered on when you attempt to power on the slot. 10. Ensure the PCI hold-down latch is closed and the board is fully seated, before continuing. 11. Go to the next section, "Powering UP the PCI Slot", to power up the slot and complete the verification of the PCI board's software driver and its operation. Powering Up a PCI Slot Use this topic to power up the PCI slot using the software interface NCMCON, which selects the correct driver. 1. Open the Novell Configuration Manager Console (NCMCON), if not already open. 39