HP LH4r HP Netserver LXr 8500 PCI Hot Plug Utility Guide - Page 20
CAUTION, the HP NetServer, to prevent the top cover from catching
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Chapter 1 Server Administration Using HP TopTools The right Power LED on the rear panel LED display should be green and the left Attention LED should be off (gray) at this point. 8. If possible, verify the PCI board's operation, before continuing. 9. If you are assured of the PCI board's operation, including its driver, continue with the next step. 10. If all desired PCI Hot Plug boards have been installed, replace the PCI access panel. Refer to the section "Removing the PCI Access Panel" in your Installation Guide. NOTE The PCI access panel uses the only short T-15 Torx® screws on the HP NetServer, to prevent the top cover from catching on the center support, when it is removed with the PCI access panel in place. CAUTION To prevent damage to cables, or a disruption in service due to a disconnection of cables, use caution when sliding the chassis into the rack, if not using the Cable Management Arm. 11. If chassis work is complete, slide the HP NetServer chassis back into the rack (refer to your Installation Guide). 12. Return the HP NetServer to normal operation (refer to your Installation Guide). 16